Highly Recommended

Electric Bike Conversion Toolkit


1000W Electric Bike Kit - 6Ah Battery

The lowest cost option in the Dillenger range of 1000W electric bike kits, while a little lower on range than other - This kit still provides all the power and torque you would expect.


£498.00
Dillenger

Product Description

Details

Low Range - Low Cost

Don't need to travel half marathons on your bike? Still want 1000W power and speed? If you only need your electric bike kit to get short distances than the 6Ah 1000W kit could be for you. Need a little more range? Why not grab an 8.8Ah battery with your kit?

Good Speed

The great benefit of owning a 1000W electric bike kit is definitely the speed. Hooning around off road on your bike, you can utilize all the torque this motor has to power you up rough terrain with ease. On the flat, you can reach a max speed of anywhere between 30 and 40 km/h

High Torque

The motor that comes with the 1000W 6Ah kit uses the latest in direct drive, high torque output brushless DC motors. Running at 48V means this has no shortage of torque. Rocketing you up to the top speed, or a hill, in no time.

Everything You Need

When purchasing a Dillenger kit, you can be sure that you're receiving all the bits and pieces you need to get up and running. Motor, wheel, battery, controller and all the peripherals.


Installation

Will this kit fit my bike?

There are thousands of different bikes out there, so there is no list to guarantee that any electric bike kit will fit any style of bike.  However almost all bikes, whether they are mountain bikes, road bikes, cruisers, choppers, BMX and most other variants have very similar measurements.

  • Standard axle slot width at approximately 10mm.
  • Standard front and rear fork dropout widths at approximately (+/-5mm) 100mm and 135mm.

When installing a kit, these are the most important measurements, so they are the ones we focus on, making our electric bike kits as close to universally compatible as you could get.

 

If you are not sure about what rim size you should be buying, the information you need to know should be on the tyre sidewall of the bike you are converting.

Will the 700C Kit Fit My 29er?

There is often confusion around this question. If your wheel is a 29er, 28″ or 700C, the correct kit for your bike is the 700C.  The 29ers can have wider rims and hubs, so double check the dropout clearance prior to ordering.  We have not yet had a 700C, 28″ or 29er that has been incompatible.  So long as you select the 700C listing and use the tyre that was on your wheel, your 29er will make a great electric bike.

Our 1,000W hub motors use a freewheel 'screw-on' style thread to mount a single, 6, 7, 8 or 9 speed gear set. This is something you can buy from Dillenger or from a bike shop however we do suggest purchasing a new freewheel because some bicycles may have a splined cassette which is incompatible and those that have a freewheel style gear set may have troubles removing it from the bicycle. The simple solution is to buy the correct gear set from us when purchasing your kit!

Additional Information

Additional Information

GENERAL

Designation 1,000W Conversion kit
Main Use Off road only
Nominal Power 1,000W
Peak Power 1,200W
Cruise Speed 18mph no pedaling
Max Speed 26mph
Max Range 19 miles
Average Range 19 miles
Throttle Only Range 7.5 miles
Throttle Type Twist throttle
Pedal Assist Levels 3 Levels
Grips Standard
Handlebar Display 880 LED
Rims Double wall eyelet
Spokes 13G stainless steel
Wiring type Standard wiring

BATTERY

Battery Chemistry LiMn2O4 Lithium Ion
Nominal Battery Voltage 48V
Charged Battery Voltage 54.6V
Battery Capacity 6Ah
Nominal Battery Energy 288Wh
Battery Removable Yes
Battery Cell Type 18650
Cell Spec Headway 18650 2200mAh
Built in BMS Yes
Maximum Battery Charge Cycles 1,000
Battery Charger Type SANS 48V 2A Smart charger with balancing
Battery Charge Time 3 hours from empty

MOTOR

Motor Brand Dillenger OEM
Motor Model 1,000W Standard wiring
Motor Voltage 48V
Max Motor Power 1,200W
Drive Type Direct drive
Motor Sensors Hall Sensor

CONTROLLER

Controller Brand Dillenger OEM
Controller Operating Voltage 48V
Controller Max Voltage 60V
Controller Low Voltage Cutoff 40V
Controller Operating Amps 22A +/- 1A
Controller Nominal Power Output 1,000W
Controller MOSFET Tubes 9
Controller Sensors Hall sensors

WEIGHT

Total Weight - No Battery 7.5kg
Battery Weight 2.4kg
Total Weight 9.9kg

GENERAL

Battery Width 90mm (round)
Battery Length 330mm
Battery Height 90mm (round) 110mm in cradle

Whats in the Box?

Reviews

Customer Reviews (2)

I'm so glad I went with an Australian company!Review by Brett Cole
Price
Overall Rating
Functions as Described
I did what Dillenger said on their website site and checked out other conversation kits. I'm so glad I went with an Australian company.

I experienced a few issues with the kit installation and Sam guided me through returning my emails and calls every time.

Thank you Sam and Dillenger for you service.
(Posted on 17/11/2014)
Strongly recommend this to anyoneReview by Chris Ferguson
Price
Overall Rating
Functions as Described
I have installed the 1000w Dillenger e-bike kit onto a Giant mountain bike. It has been a pleasure to ride and tackles dirt hills and rough terrain with ease. It has loads of torque and the top speed is exhilarating! The kit is lightweight and does not affect the ridability of the bike at all. I would strongly recommend this to anyone considering a serious off road e-bike! (Posted on 31/03/2014)

Write Your Own Review

Only registered users can write reviews. Please, log in or register

Recommended Products

You may also be interested in the following product(s)

This site uses cookies. By continuing to browse this site you are agreeing to our use of cookies.

Find out more here.
x